Fluke 773 VIP Kit

Description

You dont have to break the loop to make 4-20 mA signal measurements. Exclusive VIP Kit includes FREE Pelican 1450-C Hard case (15 x 10.5 x 6), Black and DC Voltage Detector, 6-50 VDC.

• FREE Pelican 1450-C Hard case (15 x 10.5 x 6), Black and DC Voltage Detector, 6-50 VDC Exclusively from Transcat with purchase of a 773-VIP

>

Overview

Need more hours in your day?

Save time by NOT breaking the loop on 4-20 mA signal measurements.

Are you spending time:

• Taking mA measurements by removing a wire and breaking the loop
• Calling the control room to isolate a loop
• Testing analog input/output on a console
• Troubleshooting devices with mA inputs and outputs
• Repairing intermittent or erratic 4-20 mA loops
• Going back to the shop to get extra tools

>

If you need more time in your busy day take a good look at the Fluke 773 mA Clamp Meters. Its designed to save you time, and money, by eliminating time wasting activities. Now you can troubleshoot and repair 4-20 mA loops without breaking the loop or bringing down the system.

Features

• Best in class 0.2 % accuracy
• 0.01 mA resolution and sensitivity
• Measure 4 to 20 mA signals without breaking the loop
• Measure mA signals for PLC and control system analog I/O
• Dual backlit display with both mA measurement and percent of 4 to 20 mA span
• Measurement Spotlight illuminates hard to see wires in dark enclosures
• Detachable clamp with extension cable for measurements in tight locations
• Measure 10 to 50 mA signals in older control systems using the 99.9 mA range
• Automatically change the 4 to 20 mA output for remote testing
• Power saving features, auto-off, backlight timeout extend battery life
• Hold function captures and displays changing measurements
• Measure 4 to 20 mA signals with in-circuit measurement
• Simultaneous mA in-circuit measurement with 24V loop power for powering and testing transmitters
• Source 4 to 20 mA signals for testing control system I/O or I/Ps
• mA output linear ramp or 25% step output
• DC voltage measurement to verify 24V power supplies or voltage I/O signals
• Source DC voltage to test input devices that accept a 1-5V or 0 to 10V signals
• Scaled mA output provides a continuous mA signal that corresponds to the 4 to 20 mA signal measured by the mA clamp
• mA in/out: simultaneously measure the mA signal with the clamp and source a mA signal
• Voltage output linear ramp or 25% step output

>

Each Unit Includes

• FREE 1450-C Case
• FREE DC Voltage Detector
• Soft carrying case
• Test leads
• Alligator clips
• Hanging strap
• Users manual